MPL QX2021 Rev.3 Carrera Digital Decoder Chip NOW with Pre-Wired Plugs

MPL QX2021 Rev.3 Carrera Digital Decoder Chip NOW with Pre-Wired Plugs!

Carrera Digital 1/43/132 and 1/24 compatible decoding chip - the smallest 18.5 volts chip on the market.

The pre-wired MPL chip is a great substitute for the FT SCD2022, lower profile as it does not have the light plugs built in, and it is rated to 18.5 volts with a very robust mosfet capable of handling up to 18D motors - a new Rev3 version, adding a flashing lights mode to the previous version.

The Slimmest! - only 3mm (0.11") tall/thick - ideal for F1, low bodies and tight spaces.

Smaller! - 0.96 (24.5mm) long by 0.59 (15mm) wide - install anywhere - chassis, body, etc.

Flexible! - Flat bottom side (no protruding components) for a flat easy to mount surface.

Lightweight! - only 0.05 ounces (1.6g) - Net weight without wires.

• Convert and upgrade any brand of slot car to be compatible with Carrera Digital slot tracks.
• NEW Ultra flex silicone wires with compatible plugs for power/motor, IR sensor and lights - now pre-installed!
• 10 speed and brake levels with Carrera CU's (16 steps with Cockpit-XP or Open Lap)
• Maximum operating voltage: 18.5V, Minimum 12V
• Head and tail lights and separate brake light functions ready and capable.
• NEW Flashing headlights function (aka passing/overtake signal lights). Just depress change lane controller button while driving to activate - Le Mans style!
• Pitlane function and Ghost car can only be used in conjunction with Carrera Digital Control Unit (CU) 30352.
• REV.3 Higher capacity Mosfet - can be used with 18D and high performance tuning motors.

Kit includes:

1 MPL Digital Decoder QX2021 Rev.3

1 IR Diode - aka "Sensor"

1 IR Diode chassis mounting snap-in bracker

1 Instruction sheet in English

LED Lights, capacitors, NOT INCLUDED.

NOTE: The polarity of the wires of the front headlights to the plug does not match the wire colors!

USE: FROM LED POSITIVE (+) TO NEGATIVE (-) ON THE CHIP